Fact-checked against 4 official sources on November 21, 2026How we check
Short answer

A cold climate heat pump keeps heating through an Oxford or Norfolk winter, where the Ontario Building Code design temperatures run from -15 C in Port Dover to -19 C in Woodstock. Program rules require a unit that holds at least 70% of its rated capacity at -15 C, and NRCan's 2013 test of one unit measured a heating COP of 1.5 at -21.1 C. Plan for backup heat on the coldest nights and keep the outdoor unit clear of snow.1,2,3

See what your home gets, in about a minute.

Check my rebate

How cold it gets where you live

The Ontario Building Code lists a January design temperature for each place, and the Code uses it as the outside winter design temperature. These are the values for the towns on this site:1

PlaceJanuary design temperatureHeating degree-days below 18 C
Woodstock-19 C3,910
Ingersoll-18 C3,920
Tillsonburg-17 C3,840
Simcoe-17 C3,700
Port Dover (Nanticoke)-15 C3,600

Source 1

Norwich and Delhi did not turn up as listed places in the Code data we checked, so use the nearest listed towns as a guide: Woodstock, Ingersoll and Tillsonburg for Norwich, and Simcoe and Tillsonburg for Delhi. For the rare colder night, the Code also gives a January 1% value, such as -21 C in Woodstock.1

What a heat pump delivers when it is very cold

Efficiency drops as the air gets colder, but it does not stop. In Natural Resources Canada's 2013 test of one cold climate heat pump in a research house in Ottawa, the heating COP ranged from 1.5 at -21.1 C to 3.0 at 4.9 C. With a 10 kW electric backup heater, the house stayed comfortable below -21 C.3 It is one unit in one house, so it is a guide to the trend and not a forecast for your farm. A COP of 1.5 means 1.5 units of heat for each unit of electricity.

The Ontario rebate sets a floor. Eligible units need a COP of at least 1.8 at -15 C and at least 70% of rated capacity at that temperature.2

The NRCan sizing form is where a contractor shows how the unit matches your house. Ask to see it, and read our sizing article if you want to know what it should say.2

Defrost cycles

Outdoor coils collect frost in cold, damp weather, and the unit periodically runs a defrost cycle to melt it. In NRCan's test, supply air temperature dropped during defrost until the electric backup coil warmed it, and indoor temperatures swung more than with a standard system. The test was one unit in one research house in 2013.3 Ask your installer how the backup is set to behave during defrost, and what to expect in your house.

Backup heat for your fuel

Plan on backup for the coldest hours. The program allows it, and does not pay for it.2

  • Oil homes switch fully to an electric heat pump and may add electric resistance heating where backup is necessary.
  • Propane homes may keep the propane furnace as backup, if the tank is maintained, emptied or removed under Ontario rules.4
  • Wood and electric homes may keep their existing wood or electric resistance heat.
  • Enbridge gas homes may keep a natural gas furnace or boiler.2

Oil, wood and electric homes can only use NRCan sizing options C and D, so the heat pump itself has to carry most or all of the heating.2

What changes on a rural property

Many farm homes sit at the end of a long lane, with open fields on every side. Wind and drifting snow can pile against the side of a house that faces the field, so think about which wall the unit will sit on before the installer picks a spot. Ask where the plough or the tractor pushes snow, and avoid that corner.

If the power goes out in a storm, a heat pump stops too. Ask your installer what the backup plan is for an outage, and whether your existing wood stove or furnace can keep running. This is worth settling before winter and not during the first storm.

Snow, ice and the outdoor unit

Drifts and ice around the outdoor unit block airflow. After a storm, clear snow from around it by hand and brush it off the top. Don't chip at ice on the coil. Keep the unit off the ground on a stand or wall bracket, and keep roof runoff from dripping onto it. Your installer can place it away from drifting snow and the plough pile at the end of the lane.

Ask the installer for the manufacturer's clearance instructions for your model. We don't give distances here, since they vary by unit.

Noise

The outdoor unit makes a fan and compressor sound when it runs. We found no official source with decibel figures for a typical home unit, so we won't quote any. Ask the installer where they would put the unit relative to bedrooms and your neighbour's windows, and whether the model has a quieter mode.

Read about the costs in running costs, and see heat pumps in winter for the broader picture.

See what your home qualifies for

Seven questions, about a minute, with the rules for your fuel.

Check my rebate

Common questions

Do heat pumps work at -20 C in Ontario?

Cold climate units keep heating at -20 C. In NRCan's 2013 test, one unit delivered a COP of 1.5 at -21.1 C, and the research house needed a 10 kW electric backup heater to stay comfortable below -21 C.3 Plan for backup heat on the coldest nights.

What is the coldest design temperature in Oxford County?

Among listed places on this site, Woodstock has the coldest January design temperature at -19 C.1

Do I need backup heat with a cold climate heat pump?

The program allows backup heat for every fuel type. Oil, wood and electric homes must size the heat pump to carry most or all of the heating.2

How do I keep snow off my heat pump?

Clear snow from around and on top of the unit by hand after storms, and keep roof runoff off it. Follow your manufacturer's instructions for clearances.