Fact-checked against 4 official sources on November 21, 2026How we check
Short answer

Yes, you can keep your wood stove. Under Ontario's Home Renovation Savings Program, a home heated by wood is in the larger rebate group, at $1,250 per ton, up to $7,500, and may keep its existing wood heating as backup. The stove isn't rebated itself. A wood home can use only NRCan sizing options C and D, which means the heat pump has to carry most or all of the heating.1

See what your home gets, in about a minute.

Check my rebate

What the program says about wood

For wood and electrically heated homes connected to the Ontario grid, the program lets participants keep their existing wood or electric-resistance heating as a backup. The backup source is not an eligible measure and doesn't earn a rebate.1

Wood heat sits in the same rebate group as electric, oil and propane heating. The rate is $1,250 per ton of rated heating capacity for a cold climate air source heat pump, measured at 8.3°C, up to $7,500.1 A home on Enbridge natural gas gets $500 per ton, up to $2,000.2

Your stove has to be the main heat

The program says fireplaces are not considered a primary space heating type and cannot qualify a home for the program.3 A home has to be primarily heated by wood equipment, such as a stove or a wood furnace. The pre-installation application asks wood homes for photos of the wood stoves and similar equipment.

If your wood stove is a weekend extra on top of baseboard heaters, your home may count as electrically heated instead. The rebate rate is the same, and the backup rule is the same.

Sizing options C and D only

Gas and propane homes can choose from four NRCan sizing options. Wood, oil and electric homes can choose only C or D.1

  • Option C, emphasis on heating: the heat pump provides most of the heating in mild to cold weather.
  • Option D, sized on design heating load: the heat pump provides all or nearly all of the heating over the whole season.

In a wood home, the stove becomes the backup rather than the main source. The contractor submits an NRCan sizing form for each outdoor unit, and the system must be able to heat the whole conditioned space, basement included.1 Our sizing article explains the form.

Using both in practice

Most of this is plain common sense, and your installer can tailor it to the house.

  • Let the heat pump run the base load. Set the thermostat so the heat pump carries the day. The stove can top up the room it sits in on the coldest evenings.
  • Mind where the thermostat sits. A thermostat in the same room as a hot stove will tell the heat pump the whole house is warm. Keep it away from the stove, ideally on an interior wall in a central spot.
  • Keep the stove serviced. Chimney cleaning and an annual inspection stay on your list. A heat pump doesn't change them.
  • Expect to burn less wood. With the heat pump on the job, lighting the stove becomes optional on most days.
  • Plan for outages. A heat pump needs electricity. A stove that runs without power is a real fallback in a winter storm.

A cold snap is where the stove earns its keep. Woodstock's Building Code design temperature is -19°C and Port Dover's is -15°C.4 Those are the nights a backup heat source is for.

If you have a wood furnace and ducts

Some farmhouses have a wood furnace feeding ductwork instead of a free-standing stove. A ducted heat pump can often share those ducts, but old ducts are sometimes undersized or leaky. Ask the installer to check them.

A free-standing stove in a living room is a different case. It heats one area and leaves the bedrooms to chance, so the heat pump has to reach every room. Ductless heads can do that when there are no ducts, and our ducted or ductless article compares the two.

Before you order

The heat pump also has to be a first installation. The program doesn't cover replacing an existing heat pump used for space heating.1 When the work is done, the contractor submits the post-installation application within 30 days.1 The program's help page says a cheque arrives by mail within 60 days, and an Interac e-Transfer arrives faster, within 30 days.3

A few program steps apply to a wood home as they do to any other. Pre-approval is mandatory, and installations done before approval are not eligible.2 The program pays one rebate per home, and the heat pump must be on the NRCan list of eligible cold climate models.1

The rebate checker shows which rate group you are in. The panel article covers what to ask about electrical service. If you are comparing cost, the running costs page sets electricity against other fuels.

See what your home qualifies for

Seven questions, about a minute, with the rules for your fuel.

Check my rebate

Common questions

Can I keep my wood stove if I get a heat pump?

Yes. The program lets wood heated homes keep their existing wood heating as backup. The stove isn't rebated itself.1

How much is the rebate for a wood heated home?

The program pays $1,250 per ton of heat pump capacity, up to $7,500, to the eligible owner of a wood heated home.1

Does a fireplace count as a heating system for the rebate?

No. The program says fireplaces are not considered a primary space heating type.3

What sizing option does a wood home need?

Option C or D. Both mean the heat pump handles most or all of the heating, with the stove as backup.1